Infiltration guidelines for potential stormwater hotspots Revision as of 21:03, 16 June 2015 by Mtrojan (talk | contribs) (Created page with "<Font size=3>'''Infiltration Guidelines for Potential Stormwater Hotspots'''.</font size><br> Link to this table....")(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff) Infiltration guidelines for potential stormwater hotspots

Infiltration Guidelines for Potential Stormwater Hotspots.
Link to this table.

Operational area	potential infiltration guidelines
Landscaping	Infiltration is okay as long as there is no run-on or co-mingling from higher pollutant loading areas and appropriate pre-treatment is provided for the specified practice. Chemical management is needed to limit the amount of fertilizer and pesticides.
Downspouts	Infiltration is ok as long as there is no run-on or co-mingling from higher pollutant loading areas, there is no polluting exhaust from a vent or stack deposits on the rooftop, and there is appropriate pre-treatment provided for the specific practice.
Vehicle operations	Infiltration is ok with the following provisions: No run-on from higher pollutant loading areas Limited salt application or sue of alternative deicers Enhanced pre-treatment requirements such as (suggested unless better local information is available) minimum vegetative filter lengths of 20 feet, maximum velocity in conveyance channels to infiltration practice of one foot per second, plunge pools and sediment basins/chambers with volumes of at least 25”% of the water quality volume  Only daily “commuter” parking areas and no long-term car/truck storage sites.
Waste management and outdoor material storage1	Infiltration is not typically recommended but it is possible where spill prevention and containment measures are in place, such as catch basins inserts and oil and grit separators. Infiltration is also possible if redundant treatment is provided such as filtering prior to infiltration. Infiltration should be prohibited in areas of exposed salt and mixed sand/salt storage and processing.
Loading docks1	Infiltration is not typically recommended but it is possible where spill prevention and containment measures are in place, such as catch basins inserts and oil and grit separators. Infiltration is also possible if redundant treatment is provided such as filtering prior to infiltration.
Vehicle fueling1	Infiltration is not allowed by the MPCA for new construction under the CGP.
Highways1	Infiltration is possible where enhanced pre-treatment is provided as described under parking lots. Where highways are within source water protection areas and other sensitive watersheds, additional measures should be in place such as spill prevention and containment measures (e.g., non-clogging catch basin inserts and oil and grit separators.