m
m
 
(3 intermediate revisions by the same user not shown)
Line 46: Line 46:
 
<tr>
 
<tr>
 
</table>
 
</table>
 +
 
<noinclude>
 
<noinclude>
[[Category:Sand filter table]]
+
[[Category:Level 3 - General information, reference, tables, images, and archives/Tables/Sand filter, iron enhanced sand filter, media filter]]
[[category:table]]</noinclude>
+
[[Category:Level 3 - General information, reference, tables, images, and archives/Tables/Media, compost, and media amendments]]
 +
[[Category:Level 3 - General information, reference, tables, images, and archives/Tables/Swales]]
 +
</noinclude>

Latest revision as of 16:49, 4 August 2022

This table shows sand material specifications.
Link to this table

Parameter specification Size Notes
Sand clean AASHTO M-6 or ASTM C-33 concrete sand 0.02” to 0.04” Sand substitutions such as Diabase and Graystone #10 are not acceptable. No calcium carbonated or dolomitic sand substitutions are acceptable. Rock dust cannot be substituted for sand.
Underdrain Gravel AASHTO M-43 1.5” to 3.5”
Geotextile Fabric (if required)

ASTM D-4833 (puncture strength - 125 lb.) ASTM D-1117 (Mullen Burst Strength - 400 psi)

ASTM D-4632 (Tensile Strength - 300 lb.)
0.08” thick equivalent opening size of #80 sieve Must maintain 125 gpm per sq. ft. flow rate. Note: a 4” pea gravel layer may be substituted for geotextiles meant to separate sand filter layers.
Impermeable Liner (if required)

ASTM D-4833 (thickness) ASTM D-412 (tensile strength 1,100 lb., elongation 200%) ASTM D-624 (Tear resistance - 150 lb./in)

ASTM D-471 (water adsorption: +8 to -2% mass)
30 mil thickness Liner to be ultraviolet resistant. A geotextile fabric should be used to protect the liner from puncture.
Under-drain Piping ASTM D-1785 or AASHTO M-278 minimum 4” rigid schedule 40 PVC 3/8” perf. @ 6” on center, 4 holes per row; minimum of 3” washed #57 stone over pipes; not necessary underneath pipes

This page was last edited on 4 August 2022, at 16:49.