m
m
 
Line 24: Line 24:
 
:[[file:16 - Individual vs Clumping example.docx]]
 
:[[file:16 - Individual vs Clumping example.docx]]
  
<!--
+
[[Category:Level 3 - Models and modeling/Specific models/MIDS Calculator]]
To access the examples as Microsoft Word documents, click on the appropriate link below.
 
*[[File:1 - Bioretention Basin Example.docx]]
 
*[[File:2 - Bioretention Basin with an elevated Underdrain Example.docx]]
 
*[[File:3 - Biofiltration Basin underdrain at bottom.docx]]
 
*[[File:4 - Green Roof Example.docx]]
 
*[[File:5 - Infiltration Basin example.docx]]
 
*[[File:6 - Permeable Pavement example.docx]]
 
*[[File:7- Tree Trench Systme - Box (with out an underdrain).docx]]
 
*[[File:8 - Tree Trench System - Box (with underdrain).docx]]
 
*[[File:9 - Swale Side Slope and Main Channel Example.docx]]
 
*[[File:10 - Swale Side Slope and Wet Swale Example.docx]]
 
*[[File:11 - Sand Filter example.docx]]
 
*[[File:12 - Stormwater Pond.docx]]
 
*[[File:13 - Wetland example.docx]]
 
*[[File:14 - Harvest and reuse - Cistern.docx]]
 
*[[File:15 - Other example.docx]]
 
*[[File:16 - Individual vs Clumping example.docx]]
 
*[[File:17 - BMPs in Series Example.docx]]
 
-->
 

Latest revision as of 20:18, 1 December 2022

Caution: Note these examples were written for version 2 of the calculator. The examples will be helpful with the basic functions of the calculator, but for specific applications we recommend using information from this page

For each Best Management Practice (BMP) in the Manual a page was created explaining how to apply that BMP in the Minimal Impact Design Standards (MIDS) calculator. Each page provides a discussion of the requirements, recommendations and information for using that BMP in the calculator. Each page contains an example application for the BMP. Links to those pages are shown below.

  • The MIDS calculator was developed as a site tool. Thus, BMPs are typically entered as individual entities rather than lumped together. For example, if a site has three bioretention BMPs, each BMP would be entered individually in the calculator. However, BMPs can be lumped in the calculator. In this example, the three bioretention BMPs could be combined and treated as a single BMP. Lumping BMPs has the advantage of simplifying complex site and may be useful when using the calculator for larger areas where several BMPs are implemented. Lumping BMPs can introduce errors in the calculations if the BMPs are not properly sized, since lumping smoothes out these sizing differences. The following document provides an example comparing calculator results for a site where BMPs are treated individually and lumped.
File:16 - Individual vs Clumping example.docx

This page was last edited on 1 December 2022, at 20:18.